Easy S&W Revolver Action Job

Okay, so the revolver I was working on was actually a Taurus… a .17HMR Tracker to be specific.  Here’s what you do.

Follow these easy steps for awesome results:

1.  Take off the grips.

2.  Remove the screws holding on the side plate, turn the gun over and give it a tap.  Side plate falls right out.

3.  Remove old lubricant from inside the lockwork.

4.  Shake your Slipstream Bottle for a minute.

5.  Apply Slipstream to the Lockwork.

6.  Apply Slipstream to the cylinder crane and ejector.

7.  Reassemble and wipe down.   Done.

Once I was finished with this Taurus, this thing felt like it was a S&W Pro Series.  Not quite up there with a Performance Center, but really damn good.   Most guys would be giddy to have their S&W feel this good.

2 thoughts on “Easy S&W Revolver Action Job”

  1. Holy Crap! I just did this with my S&W 442, it just rolls through!

    Excellent product George, the trigger pull is smoothed out and I used to get the dreaded, J-Frame front sight wobble. No more, this stuff is awesome!

  2. I’ve been applying Slipstream to all my weapons as I cycle them through my cleaning schedule.
    The last recipient of your product was a Swedish Mauser made in 1911. If I weren’t already married I’d have proposed right there at the range. As it is my wife does NOT like all the time I’ve spent with the rifle. Cycles like … well, if the stories my Uncle John told ’bout the Craig are true like that. Two guys a few lanes over were shooting a M-N 44. I let them put a few rounds through my Swede. They packed up and left. One wanted to leave “that Russian piece of crap” behind but the range officer said they had to take it.

Leave a Reply to LouisCQ Cancel reply

Your email address will not be published. Required fields are marked *